Home>ASME standards>ASME B16.49-2012 pdf download

ASME B16.49-2012 pdf download

ASME B16.49-2012 pdf download.Factory-Made, Wrought Steel, Buttwelding Induction Bends for Transportation and Distribution Systems.
1 SCOPE AND DEFINITIONS 1.1 General This Standard covers design, material, manufacturing, testing, marking, and inspection requirements for factory-made pipeline bends of carbon steel materials having controlled chemistry and mechanical properties, produced by the induction bending process, with or without tangents. This Standard covers induction bends for transportation and distribution piping applications (e.g., ASME B31.4 and B31.8). Process and power piping have differing requirements and materials that may not be appropriate for the restrictions and examinations described herein and, therefore, are not included in this Standard. 1.2 Manufacturing Process This process utilizes induction heating to heat a nar- row band 360 deg around a pipe or cylinder at the point of bending as the pipe or cylinder is being pushed through the inductor coil at a constant velocity. After the material passes through the coil, it may be cooled by forced air or water spray, or it may be allowed to cool in still air. Bends in any producible wall thickness and diameter are covered. Induction bends covered by this Standard may be produced from seamless pipe, welded pipe, or cylinders. 1.3 Fabricated Bends Larger angle bends obtained by girth welding two or more smaller angle bends together are considered pipe fabrications and as such, are not within the scope of this Standard. 1.4 Standard Units The values stated in either metric units or U.S. Customary units are to be regarded separately as standard. Within the text, Customary values are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from two systems may result in nonconformance with the Standard. 1.5 References Standards and specifications adopted by reference in this Standard are shown in Mandatory Appendix I. It 1 is not practical to identify the specific edition of each standard and specification in the individual references. Instead, the specific edition reference is identified in Mandatory Appendix I. A productmade in conformance with a prior edition of reference standards and in all other respects conforming to this Standard will be con- sidered to be in compliance. 1.6 Codes and Regulations A bend used under the jurisdiction of a referencing code or governmental regulation is subject to any limita- tion of that code or regulation. This includes any maxi- mum temperature limitation or rule governing the use of a material at low temperature. 1.7 Service Conditions Criteria for selection of bend material for a particular fluid service are not within the scope of this Standard. 1.8 Convention For determining conformance with this Standard, the convention for fixing significant digits where limits, maximum and minimum values, are specified shall be as defined in ASTM Practice E29. This requires that an observed or calculated value be rounded off to the near- est unit in the last right-hand digit used for expressing the limit. Decimal values and tolerance do not imply a particular method of measurement. 1.9 Quality Systems Requirements relating to the manufacturers’ quality system programs are described in Nonmandatory Appendix A. 1.10 Glossary bend qualification procedure: a document that specifies the properties ofthe starting pipe; the equipmentto be used; the bending parameters; the qualification bend test results; and the postbend, heat-treat equipment and cycle used for the manufacture of the bends. If nonde- structive testing of the bend is required, procedures that have not been approved previously shall be submitted. cylinder: a jointofpipe produced bya rollingand welding plate, as opposed to a joint of pipe produced in accor- dance with a recognized specification.

Related PowerPoint Templates

Template Categories
Popular Tags